|
Post by chalky64 on Sept 4, 2014 22:33:07 GMT
In the hope that this product is still active, I was wondering if anyone can advise me as to whether I could create a curved turnout from a straight turnout kit? The curve I need would be very gentle - and I was thinking that I could maybe cut the base between each sleeper and push each one together to create the desired arc?
|
|
|
Post by Wayne Kinney on Sept 8, 2014 12:52:59 GMT
Hi,
Welcome to the forum.
This has been achieved by one of my customers, cutting the webbing of the straight turnout - it works well so long as the curve is not too sharp radius.
|
|