|
Post by ntrain on Jun 3, 2013 20:01:53 GMT
I haven't spotted yet, how the switch mechanism is going to work.
Been trying to think it through, but still a bit on the slow side after my little to-do last week.
Looks like I need to buy myself a file and some glue. Got to go up town tomorrow, so will see what I can pick up. Now where is my soldering, solder and flux.....................
|
|
karyn
New Member
Posts: 18
|
Post by karyn on Jun 3, 2013 20:28:42 GMT
Wayne is producing some pre-shaped point blades for us that solder to the ends of standard rail. The blades have a pin underneath which attaches to a tie bar we're yet to get. How you operate the tie bar will be up to you.
I have a DCC Concepts point motor to play with and I'm also going to experiment with some small servos.
|
|
|
Post by ntrain on Jun 3, 2013 20:40:10 GMT
Aha, the missing link. The tie bar we haven't got yet.
Said I was a bit slow at the moment. On holiday next week to get away from it all, so asking as many stupid questions as I can now............
|
|
|
Post by Wayne Kinney on Jun 5, 2013 7:54:57 GMT
The caster will be casting the switch blades this week, so I should be able to forward them Early next week
|
|
|
Post by ntrain on Jun 9, 2013 14:20:22 GMT
Will be on holiday this next week, so hope to have a nice little package when I return. I can then dive in with my best two left feet.................
|
|